How to Use the WAKA PA25000

The WAKA PA25000 is draw-activated, so there is no power button — you remove the packaging and inhale. Two clicks switch between Regular and Boost mode, a slider underneath adjusts airflow across three settings, and the dual screen shows battery and e-liquid levels. It charges by USB-C.

Most of what people search for on this device comes down to three controls they cannot find: the mode switch, the airflow slider and what the screen is actually telling them. This guide covers all three, plus charging, troubleshooting and storage in UAE heat, which matters more here than the manufacturer’s generic advice suggests. Everything below applies to the WAKA PA25000 specifically.

Quick Summary:

• No power button. The device is draw-activated — inhale and it fires.
• Two clicks switch mode. Regular runs at 15W, Boost at 25W.
• Boost mode costs you device life. Across the WAKA range, Boost cuts total puffs by roughly 30%.
• Three airflow settings are adjusted by a slider on the base.
• Charge with a standard USB-C, not a fast charger. 800 mAh takes about 45 minutes.
• Never leave it in a parked car in Dubai. Cabin temperatures far exceed the device’s safe range.
• Contains nicotine, which is addictive. For adults aged 18 and over only.

First Setup: Four Steps

Getting started takes under a minute. The single most common reason a new device does not fire is step two.

1. Remove the outer wrap and the device from its box. Keep the box until you have confirmed the device works.
2. Peel off the protective sticker covering the airflow inlet on the base. This is the step people miss. A device with the sticker still on will not draw air, will not trigger the sensor, and will feel completely dead.
3. Take a firm, steady draw of about two seconds. Draw-activated sensors need a proper pull, not a gentle sip. The screen lights up when it fires.
4. Check the screen shows both battery and liquid levels. If the battery reads low out of the box, charge it before first use — devices sit in storage and self-discharge.

That is the whole setup. There is nothing to prime, nothing to fill and no button to hold.

Switching Between Regular and Boost Mode

Click the mode button twice in quick succession to switch between Regular and Boost. The PA25000 runs Regular at 15W and Boost at 25W, and the screen indicates which mode is active.

Boost delivers a warmer, denser draw with more pronounced flavour. It also consumes liquid and battery considerably faster. WAKA publishes the trade-off openly on its higher-tier devices — the WAKA Blast 50000 is rated at 50,000 puffs in Regular mode and 35,000 in Boost, a drop of 30 per cent. The PA25000 behaves the same way.

The practical advice: run Regular by default and switch to Boost when you want a fuller hit. Leaving it in Boost permanently means charging more often and replacing the device sooner, which is a fair trade only if you actually prefer the draw.

Adjusting the Airflow

The airflow slider sits on the base of the device and moves across three positions. Closed gives a tight, cigarette-like mouth-to-lung draw. Open gives a loose direct-lung draw with more vapour. The middle setting sits between the two.

Airflow changes the experience more than most people expect. A tighter setting concentrates flavour and uses less liquid per puff; a looser setting produces more vapour and burns through the tank faster. If a flavour tastes weak, close the airflow before assuming the device is faulty.

Reading the Dual Screen

The PA25000 has two indicators: e-liquid level and battery level. Both display as a segmented bar that empties as each depletes.

The two rarely run down together, and that is normal rather than a fault. With 22 ml of liquid behind an 800 mAh battery, the battery empties several times over the life of one tank. If the liquid bar is still showing half and the battery bar is empty, the device is telling you to charge it, not to replace it.

When the liquid indicator empties, the device is finished. There is nothing to refill.

Charging It Correctly

Charge with a standard USB-C cable from a normal phone charger or laptop port. An 800 mAh battery reaches full in roughly 45 minutes from empty.

• Avoid high-wattage fast chargers. Rapid charging generates heat in a cell that is not designed for it, and heat is what degrades disposable batteries fastest.
• Unplug when the screen shows full. Leaving it connected overnight serves no purpose.
• Do not charge it unattended or overnight, particularly on a bed or sofa.
• Do not use a damaged cable, and do not charge a device that has been dropped in liquid.

Troubleshooting

Almost every problem on this device traces back to one of five causes.

Storage in the UAE Climate

Store the device between 15°C and 25°C, upright, out of direct sunlight. This matters far more in the UAE than the generic guidance on the packaging suggests.

A car parked in Dubai in July reaches cabin temperatures well above anything a lithium cell or a sealed liquid reservoir is designed for. Heat thins e-liquid, which causes leaking and spitback, and it degrades battery capacity permanently. A device left on a dashboard for an afternoon can come back with noticeably shorter runtime for the rest of its life.

Two habits solve it: take the device with you rather than leaving it in the car, and let it return to room temperature before using it if it has been somewhere hot.

Disposal. The PA25000 contains a lithium battery and should not go in household waste. Use an electronics or battery collection point.

Frequently Asked Questions

Q: How do I turn on the WAKA PA25000?

A: There is no power switch. The device is draw-activated, so it turns on when you inhale. If nothing happens, the protective sticker over the airflow inlet on the base is almost certainly still attached — peel it off and take a firm two-second draw rather than a gentle sip.

Q: How do I switch the WAKA PA25000 to Boost mode?

A: Click the mode button twice in quick succession. Regular mode runs at 15W and Boost at 25W, and the screen shows which is active. Boost gives a warmer, denser draw but shortens the device’s life by around 30 per cent, so most users run Regular by default.

Q: How long does the WAKA PA25000 take to charge?

A: About 45 minutes from empty using a standard USB-C cable. Avoid high-wattage fast chargers, which generate heat that permanently reduces battery capacity. Unplug the device once the screen indicates a full charge rather than leaving it connected overnight.

Q: Why does my WAKA still have liquid but no battery?

A: That is normal. The device holds 22 ml of e-liquid behind an 800 mAh battery, so the battery empties several times before the liquid runs out. An empty battery bar with liquid remaining means charge it, not replace it. The device is finished only when the liquid indicator empties.

Q: Can I leave my WAKA in the car in Dubai?

A: No. Parked-car temperatures in the UAE summer far exceed the safe range for a lithium battery and a sealed liquid reservoir. Heat causes leaking and spitback and permanently reduces battery capacity. Store the device between 15°C and 25°C and let it cool to room temperature before use if it has been somewhere hot.

Conclusion

The PA25000 is simpler than its screen suggests: peel the sticker, draw firmly, double-click for Boost when you want it, slide the airflow to taste, and charge with a normal cable. The only habit worth building is keeping it out of the heat.

If you are still deciding which tier or device suits you, start with our complete disposable vape buying guide for Dubai.

This product contains nicotine, which is an addictive substance. For sale to adults aged 18 and over only.